2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

HINT:
  1. Use the following procedures to troubleshoot the key reminder warning system.
  2. The intelligent tester should be used in steps 3 and 5.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard voltage:
      10 to 14 V

      If the voltage is below 10 V, recharge or replace the battery before proceeding to the next step.

    NEXT

    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result:
      Result
      Proceed to
      (ECU connected, communication line malfunctioning) If no code is output.
      A
      (ECU connected, communication line malfunctioning) If code is output.
      B
      for LHD without Smart Entry and Start System: Click here
      for RHD without Smart Entry and Start System: Click here


    B.
    A

    4.PROBLEM SYMPTOMS TABLE
    1. If the fault is not listed in the problem symptoms table, proceed to A.

    2. If the fault is listed in the problem symptoms table, proceed to B.


    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. DATA LIST / ACTIVE TEST (Click here)

    2. TERMINALS OF ECU (Click here)

    NEXT

    6.REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Jun 2006 – Sep 2006)HOW TO PROCEED WITH TROUBLESHOOTING (from Jun 2009) →