Height Control Sensor Circuit
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
DESCRIPTION
The headlight leveling ECU receives a signal from the rear height control sensor to detect the vehicle height.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY |
Connect 3 dry cell batteries (1.5 V) in series.

Remove the rear height control sensor sub-assembly.
Connect the positive (+) lead from the battery to terminal 3, and the negative (-) lead from the battery to terminal 1.
Measure the voltage between terminals 2 and 1 while slowly moving the link up and down.
- Standard voltage:
Tester Connection
Condition
Specified Condition
2 (SHRR) - 1 (SHG)
+45° (High)
Approx. 4.05 V
0° (Normal)
Approx. 2.25 V
-45° (Low)
Approx. 0.45 V
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (ECU - REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY) |
Disconnect the O23 rear height control sensor sub-assembly connector.

Disconnect the A20 headlight leveling ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
A20-12 (SBR) - O23-3 (SHB)
Always
Below 1 Ω
A20-19 (SHRL) - O23-2 (SHRR)
Always
Below 1 Ω
A20-21 (SGR) - O23-1 (SHG)
Always
Below 1 Ω
A20-12 (SBR) - Body ground
Always
10 kΩ or higher
A20-19 (SHRL) - Body ground
Always
10 kΩ or higher
A20-21 (SGR) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
