Headlight Leveling ECU Power Source Circuit
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
DESCRIPTION
This circuit detects the state of the ignition switch, and sends it to the headlight leveling ECU.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT LEVELING ECU) |
Disconnect the A20 headlight leveling ECU connector.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
A20-1 (IG) - Body ground
Ignition switch on (IG)
10 to 14 V
A20-1 (IG) - Body ground
Ignition switch off
Below 1 V
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
A20-9 (E1) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
