2006-2011 Camry Aurion · Service Manual BODY

Rear Power Window Motor LH Circuit

Circuit diagnosis · Vehicles built from Jun 2006

DESCRIPTION

This circuit transmits signals from the power window regulator switch assembly (Rear LH) to the power window regulator motor (Rear LH).

WIRING DIAGRAM

B137065E06

INSPECTION PROCEDURE


1. INSPECT POWER WINDOW REGULATOR MOTOR

  1. B127536E02
    Remove the power window motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor gear rotates counterclockwise



NG
REPLACE POWER WINDOW REGULATOR MOTOR
OK


2. CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - WINDOW REGULATOR SWITCH)

  1. B137066E02
    Disconnect the K1 and K3 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K1-4 (U) - K3-1
    Always
    Below 1 Ω
    K1-1 (D) - K3-2
    Always
    Below 1 Ω
    K1-4 (U) - Body ground
    Always
    10 kΩ or higher
    K1-1 (D) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Front Passenger Side Power Window Motor Circuit (from Jun 2006)Rear Power Window Motor RH Circuit (from Jun 2006) →