Front Passenger Side Power Window Motor Circuit
Circuit diagnosis · Vehicles built from Jun 2006
DESCRIPTION
This circuit transmits signals from the power window regulator switch assembly (Front passenger) to the power window regulator motor (Front passenger).WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT POWER WINDOW REGULATOR MOTOR |
Remove the power window motor.

Apply battery voltage to the motor connector according to the table below.
- NOTICE:
- Do not apply battery voltage to any terminals except terminals 1 and 2.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Motor gear rotates clockwise
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 1
Motor gear rotates counterclockwise
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - POWER WINDOW REGULATOR SWITCH) |
Disconnect the H6 (I9) and H4 (I4) connectors.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
- LHD models:
Tester Connection
Condition
Specified Condition
H6-4 (U) - H4-2
Always
Below 1 Ω
H6-1 (D) - H4-1
Always
Below 1 Ω
H6-4 (U) - Body ground
Always
10 kΩ or higher
H6-1 (D) - Body ground
Always
10 kΩ or higher
- RHD models:
Tester Connection
Condition
Specified Condition
I9-4 (U) - I4-2
Always
Below 1 Ω
I9-1 (D) - I4-1
Always
Below 1 Ω
I9-4 (U) - Body ground
Always
10 kΩ or higher
I9-1 (D) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
