2006-2011 Camry Aurion · Service Manual BODY

Power Source Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This is the power source circuit for the outer mirror control ECU.

WIRING DIAGRAM

B145512E04

INSPECTION PROCEDURE


1. INSPECT OUTER MIRROR CONTROL ECU (POWER SOURCE)

  1. B145477E04
    Disconnect the E86 connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E86-3 (B) - Body ground
    Always
    10 to 14 V
    E86-4 (ACC) - Body ground
    Engine switch on (ACC)
    10 to 14 V

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E86-9 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Power Mirrors do not Return to Memorized Position (from Oct 2006)Power Source Circuit (from Jun 2009) →