Power Source Circuit
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This is the power source circuit for the outer mirror control ECU.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT OUTER MIRROR CONTROL ECU (POWER SOURCE) |
 |
- Disconnect the E95 connector.
Measure the voltage and resistance according to the value(s) in the table below.
- Standard voltage:
Tester Connection
|
Condition
|
Specified Condition
|
E95-3 (B) - Body ground
|
Always
|
10 to 14 V
|
E95-4 (ACC) - Body ground
|
Engine switch on (ACC)
|
10 to 14 V
|
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
E95-9 (GND) - Body ground
|
Always
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE WIRE HARNESS |
|
|
| OK |
|
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|