DATA LIST / ACTIVE TEST
System information · Vehicles built from Oct 2006
| USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Monitor the ECU data by following the prompts on the tester screen.
- HINT:
- The intelligent tester has a "Snapshot" function which records the monitored data. Refer to the intelligent tester operator's manual for further details.
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Read the Data List according to the display on the tester.
- Mirror-L/Mirror-R:
Tester Display
Measurement Item/Range
Normal Condition
RH Mir Pos Sen V
Vertical mirror position/MIN: 0, MAX: 5 V
Within range from 0 to 5 V
RH Mir Pos Sen V
Vertical mirror position/MIN: 0, MAX: 5 V
Within range from 0 to 5 V
LH Mir Pos Sen H
Horizontal mirror position/MIN: 0, MAX: 5 V
Within range from 0 to 5 V
LH Mir Pos Sen H
Horizontal mirror position/MIN: 0, MAX: 5 V
Within range from 0 to 5 V
Mirror Mem 1
Mirror position memorized in memory switch M1/ON (1) or OFF (0)
1: Memorized
0: Not memorized
Mirror Mem 2
Mirror position memorized in memory switch M2/ON (1) or OFF (0)
1: Memorized
0: Not memorized
D Set Memory
Driving position memorized in seat memory switch MEMORY/ON (1) or OFF (0)
1: Memorized
0: Not memorized
D Mem 1 SW
Driving position memorized in seat memory switch M1/ON (1) or OFF (0)
1: Memorized
0: Not memorized
D Mem 2 SW
Driving position memorized in seat memory switch M2/ON (1) or OFF (0)
1: Memorized
0: Not memorized
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Perform the Active Test according to the display on the tester.
- Mirror-L/Mirror-R:
Tester Display
Test Part
Control Range
RH Mirror Up/Down
Mirror vertical operation: UP/DOWN
-
RH Mirror Right/Left
Mirror horizontal operation: RIGHT/LEFT
-
LH Mirror Up/Down
Mirror vertical operation: UP/DOWN
-
LH Mirror Right/Left
Mirror horizontal operation: RIGHT/LEFT
-