Radio Receiver Power Source Circuit
Circuit diagnosis · Vehicles built from Jun 2009
DESCRIPTION
This circuit provides power to the radio and display assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT RADIO AND DISPLAY ASSEMBLY |
Disconnect the F6 radio and display assembly connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F6-7 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
F6-4 (B) - F6-7 (GND)
Always
11 to 14 V
F6-3 (ACC) - F6-7 (GND)
Ignition switch on (ACC)
11 to 14 V
|
|
||||
| OK | ||
| ||
