2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Stereo Component Amplifier Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2009

DESCRIPTION

This circuit provides power to the stereo component amplifier.

WIRING DIAGRAM

E190644E04

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT STEREO COMPONENT AMPLIFIER

  1. E190870E07
    Disconnect the stereo component amplifier connector.

  1. Measure the resistance according to the value(s) in the table below .

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F46-10 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F46-5 (+B) - F46-10 (GND)
    Always
    11 to 14 V
    F46-12 (ACC) - F46-10 (GND)
    Ignition switch on (ACC)
    11 to 14 V

Text in Illustration 
*1
Front view of wire harness connector
(to Stereo Component Amplifier)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT STEREO COMPONENT AMPLIFIER

  1. E190870E06
    Disconnect the stereo component amplifier connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F46-9 (AMP+) - F46-10 (GND)
    Ignition switch on (IG)
    11 to 14 V

Text in Illustration 
*1
Front view of wire harness connector
(to Stereo Component Amplifier)


NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

3. CHECK HARNESS AND CONNECTOR
  1. Disconnect the stereo component amplifier and radio receiver connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F46-9 (AMP+) - F6-9 (AMP)
    Always
    Below 1 Ω
    F46-9 (AMP+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE RADIO RECEIVER


← Radio Receiver Power Source Circuit (from Oct 2006)PRECAUTION (from Jun 2009) →