2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

DATA LIST / ACTIVE TEST

System information · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006


DATA LIST
According to the Data List displayed by the intelligent tester, you can read the values of the switches, sensors, actuators and so on without parts removal. Reading the Data List as the first step of troubleshooting is one method to shorten work time.
  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch to the ON position.

  5. Turn the tester ON.

  6. Enter following menus:

    1. for Combination Meter: Body / Combination Meter / Data List

    2. for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List

    3. for Engine: Power train / Engine / Data List

  7. Check values by referring to the table below.

    Combination Meter: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ODO/TRIP Change SW
    ODO/TRIP switch is ON/OFF
    ON: Switch is pushed
    -
    OFF: Switch is released
    -
    P-Seatbelt Buckle SW (*1)
    Front passenger buckle switch is ON/OFF
    ON: Seat belt is unfastened
    -
    OFF: Seat belt is fastened
    -
    Vehicle Speed Meter
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    Almost same as actual vehicle speed (When driving)
    If data received from the skid control ECU exceeds the range that can be displayed on the meter, the meter continues to display the maximum value of the range.
    Engine Rpm
    Engine speed/Min.: 0 rpm, Max.: 12,750 rpm
    Almost same at the meter rpm (When engine is running)
    If data received from the ECM exceeds the range that can be displayed on the meter, the meter continues to display the maximum value of the range.
    Coolant Temperature
    Engine coolant temperature 0°C (32°F) to 127.5°C (261.5°F)
    After warming up: 78 to 105°C (172 to 221°F) (*2)
    After warning up: 95 to 105°C (203 to 221°F) (*1)
    1. If -40°C (-40°F): sensor circuit open
    2. If 140°C (284°F) or more: sensor circuit shorted
    Light Control Switch
    Light control switch is ON/OFF
    ON: Light control switch is pushed
    -
    OFF: Light control switch is released
    -
    Multi Display Select Switch
    MODE switch in the steering pad is ON/OFF
    ON: Mode switch is ON
    -
    OFF: Mode switch is OFF
    -
    +B Voltage Value
    Battery voltage/Min.: 0 V, Max.: 25.5 V
    10 to 14 V
    -
    Fuel Input
    Fuel input signal Min.: 0, Max. 127.5
    Fuel gauge indicates (F): 62.9 (L)
    -
    Fuel gauge indicates (3/4): 52.5 (L)
    -
    Fuel gauge indicates (1/2): 35.0 (L)
    -
    Fuel gauge indicates (1/4): 17.5 (L)
    -
    Fuel gauge indicates (E): 7.0 (L)
    -
    Ambient Temperature
    Outside temperature: Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F)
    Almost same as actual outside temperature
    The temperature displayed on the multi-information display/Min.: -30°C (-22°F), Max.: 50°C (122°F)
    Communication ECM/Meter DTC 1/2/3
    The history of communication error/Unrec, Rec
    Unrec: Not occurred
    -
    Rec: Occurred
    ECM ODO (History 1/2/3)
    Value when DTC is output Min.: 0, Max.: 999999
    -
    -
    Communication ABS/Meter DTC 1/2/3
    The history of communication error/Unrec, Rec
    Unrec: Not occurred
    -
    Rec: Occurred
    ABS/VSC ODO (History 1/2/3)
    Value when DTC is output Min.: 0, Max.: 999999
    -
    -
    Key Remind Sound
    The cycle of the key reminder warning buzzer is Fast, Normal, Slow
    The customized setting of the cycle of the key reminder warning buzzer is displayed.
    -
    Seat-belt Warning Buzzer
    The inquiry of the seat belt warning buzzer is D/P ON, D ON, P ON, D/P OFF
    The customized setting of the inquiry of the seat belt warning buzzer is displayed.
    -
    Key Remind Volume
    The volume of the key reminder warning buzzer is Large, Medium, Small
    The customized setting of the volume of the key reminder warning buzzer is displayed.
    -
    Number of Trouble Code
    The number of the trouble code which is currently output
    0
    -
    *1: for G.C.C. Countries
    *2: Except for G.C.C. Countries
    ABS/VSC/TRC: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FR Wheel Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    FL Wheel Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    RR Wheel Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    RL Wheel Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    Vehicle Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    Engine: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Vehicle speed/Min.: 0 rpm, Max.: 16,383.75 rpm
    Almost same as actual engine speed (When driving)
    -
    Coolant Temp
    Engine coolant temperature:
    Min.: -40°C (-40°F), Max.: 140°C (284°F)
    80°C to 100°C (176°F to 212°F):
    After warming up
    1. If -40°C (-40°F): sensor circuit open
    1. If 140°C (284°F) or more: sensor circuit shorted


ACTIVE TEST
Performing the Active Test using the intelligent tester allows the meters, indicators and so on to operate without parts removal. Performing the Active Test as the first step of troubleshooting is one way to shorten labor time.
It is possible to display the Data List on the intelligent tester during the Active Test.
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the tester ON.

  4. Enter following menus: Body / Combination Meter / Active Test.

  5. According to the display on the tester, perform the "Active Test".

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Normal Condition
    Speed Meter Operation
    Speedometer
    Speedometer indicates 0, 40 (24), 80 (48), 120 (72), 160 (96), 200 (120) km/h (mph)
    -
    Tacho Meter Operation
    Tachometer
    Tachometer indicates 0, 1,000, 2,000, 3,000, 4,000, 5,000, 6,000, 7,000 (rpm)
    -
    Fuel Meter Operation
    Fuel receiver gauge
    Fuel receiver gauge indicates EMPTY, 1/2, FULL
    -
    Water Temperature Meter Operation
    Engine coolant temperature receiver gauge
    Engine coolant temperature receiver gauge indicates LOW, NORM, HIGH
    -
    A/T Indicator Operation 1 (*1)
    A/T shift indicator light
    A/T shift indicator light L, 2, 3, 4, D, N, R, P is OFF/ON
    -
    Meter Display 1 (*2)
    Multi-information display
    All the segment in the multi-information display is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Meter Display 2 (*2)
    A/T shift indicator display
    All the segment in the A/T shift indicator display is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Airbag
    Airbag warning light
    Airbag warning light is OFF/ON
    -
    Indicat. Lamp Doors All Open
    Open door indicator light
    Open door indicator light is OFF/ON
    -
    Indicat. Lamp P-seat Belt (*3)
    Front passenger side seat belt warning light
    Front passenger side seat belt warning light is OFF/ON
    -
    Indicat. Lamp D-seat Belt
    Driver side seat belt warning light
    Driver side seat belt warning light is OFF/ON
    -
    Indicat. Lamp ABS
    ABS warning light
    ABS warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp VSC (*4)
    VSC warning light
    VSC warning light is OFF/ON
    -
    Indicat. Lamp Slip (*4)
    Slip indicator light
    Slip indicator light is OFF/ON
    -
    Indicat. Lamp Beam
    Hi-beam indicator light
    Hi-beam indicator light is OFF/ON
    -
    Indicat. Lamp Fr FOG (*5)
    Front fog indicator light
    Front fog indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp D/P/RR/RL/Luggage Door Open
    Door open indicator light
    Door open indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Fuel
    Fuel warning light
    Fuel warning light is OFF/ON
    -
    Indicat. Lamp Cruise (*6)
    Cruise indicator light
    Cruise indicator light is OFF/ON
    -
    Indicat. Lamp Brake
    Brake warning light
    Brake warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Over Speed (*3)
    Speed limit warning light
    Speed limit warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    *1: for Automatic Transaxle
    *2: with Multi-information Display
    *3: for G.C.C. Countries
    *4: with VSC
    *5: with Front Fog Light
    *6: with Cruise Control System

← FAIL-SAFE CHART (from Oct 2006)DATA LIST / ACTIVE TEST (from Oct 2006) →