2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Entire Combination Meter does not Operate

Circuit diagnosis · Vehicles built from Oct 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006

DESCRIPTION

This circuit is the power source circuit for the meter. This circuit provides two types of power sources; one is a constant power source mainly used as a backup power source, and the other is a power source mainly used for signal transmission. The constant power source is mainly used as a backup power source of the meter CPU, however, it is also used for communication. If a voltage of 12 V is not applied to terminal IG+ when turn the ignition switch on (IG), the indicator will not operate.

WIRING DIAGRAM

E136506E01

INSPECTION PROCEDURE


1. INSPECT COMBINATION METER ASSEMBLY

  1. E134491E04
    for 2AZ-FE:
    1. Disconnect the F1 connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      F1-12 (E2) - Body ground
      Always
      Below 1 Ω
      F1-24 (ES) - Body ground
      Always
      Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard voltage:
      Tester Connection
      Condition
      Specified Condition
      F1-1 (B) - Body ground
      Always
      10 to 14 V
      F1-2 (B2) - Body ground
      Always
      10 to 14 V
      F1-13 (IG+) - Body ground
      Ignition switch on (IG)
      10 to 14 V

  1. E123360E15
    for 2GR-FE:
    1. Disconnect the F1 connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      F1-12 (E2) - Body ground
      Always
      Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard voltage:
      Tester Connection
      Condition
      Specified Condition
      F1-1 (B) - Body ground
      Always
      10 to 14 V
      F1-2 (B2) - Body ground
      Always
      10 to 14 V
      F1-13 (IG+) - Body ground
      Ignition switch on (IG)
      10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY


← Entire Combination Meter does not Operate (Jun 2006 – Sep 2006)Speedometer Malfunction (Jun 2006 – Sep 2006) →