Using SST, fully tighten the air fuel ratio sensor.
SST
09224-00010
Torque:
44 N*m{
449 kgf*cm
, 32 ft.*lbf
}
NOTICE:
The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (Click here).
Connect the air fuel ratio sensor connector and clamp.
2.
INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
Install the exhaust manifold heat insulator with the 4 bolts.