2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jun 2009

HINT:
Use the following procedure to troubleshoot the rear view monitor system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.INSPECT BATTERY VOLTAGE

        Standard Voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
      NEXT

      4.PROBLEM SYMPTOM CONFIRMATION
        Result 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B

      B.
      A

      5.SYMPTOM SIMULATION
        NEXT

        6.CHECK IF SAME SYMPTOM APPEARS IN AUDIO AND VISUAL SYSTEM
        1. Refer to Audio and Visual System (for radio and display type) (Click here).

          Result 
          Result
          Proceed to
          Symptom does not appear
          A
          Symptom appears
          B


        B.
        A

        7.PROBLEM SYMPTOMS TABLE
        1. Refer to Problem Symptoms Table (Click here).

          Result 
          Result
          Proceed to
          Fault is not listed in Problem Symptoms Table
          A
          Fault is listed in Problem Symptoms Table
          B


        B.
        A

        8.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW
        1. Refer to Terminals of ECU (Click here).

        NEXT

        9.ADJUST, REPAIR OR REPLACE
          NEXT

          10.CONFIRMATION TEST
            NEXT

            ← SYSTEM DESCRIPTION (from Jun 2009)PROBLEM SYMPTOMS TABLE (from Jun 2009) →