2006-2011 Camry Aurion · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE COOL AIR INTAKE DUCT SEAL

  1. A141576E01
    Remove the 7 clips and intake duct seal.


3. REMOVE AIR CLEANER INLET ASSEMBLY

  1. A132969
    Remove the 2 bolts, clamp and air cleaner inlet.


4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A135704
    Disconnect the 3 vacuum hoses.

  1. A135705E01
    Disconnect the mass air flow meter connector (*1).

  1. Disconnect the No. 2 ventilation hose (*2).

  1. Disconnect the hose band (*3).

  1. A135706
    Disconnect the 3 bands, and remove the air cleaner cap sub-assembly.


5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

  1. A132971
    Disconnect the vacuum hose and hose clamp.

  1. Remove the 3 bolts and air cleaner case.


6. REMOVE NO. 1 AIR CLEANER INLET

  1. A132970
    Remove the bolt and No. 1 air cleaner inlet.


7. REMOVE AIR CLEANER BRACKET

  1. C132235
    Separate the wire harness clamp.

  1. Remove the 3 bolts and air cleaner bracket.


8. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

  1. C132237
    Remove the clip from the transmission cable bracket.

  1. C132236
    Remove the nut and transmission control cable from the control shaft lever.

  1. Disconnect the connector from the park/neutral position switch.

  1. C136685
    Remove the nut, washer and control shaft lever from the control shaft.

  1. C135732
    Remove the 2 bolts and park/neutral position switch from the control shaft.

    NOTICE:
    Before removing the park/neutral position switch, remove any dirt or rust on the control shaft. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch cannot be reinstalled correctly.

← ON-VEHICLE INSPECTION (from Oct 2006)REMOVAL (from Jun 2009) →