2006-2011 Camry Aurion · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

  1. A079305E04
    Using a vernier caliper, measure the brush length.

    Standard length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum length:
    4.5 mm (0.177 in.)

    If the brush length is less than the minimum, replace the generator brush holder assembly.


INSPECT GENERATOR ROTOR ASSEMBLY

  1. A097469E01
    Check the appearance.

    1. Check that the bearing is not rough or worn.

      OK:
      The bearing rotates smoothly.

      If the result is not as specified, replace the generator rotor assembly.

  1. A097476E02
    Check the resistance.

    1. Measure the resistance between the slip rings.

      Standard Resistance:
      Condition
      Specified Condition
      Approx. 20°C (68°F)
      1.8 to 2.3 Ω

      If the result is not as specified, replace the generator rotor assembly.

    2. A097477E02
      Measure the resistance between the slip ring and rotor core.

      Standard Resistance:
      Tester Connection
      Specified Condition
      Slip ring - Rotor core
      1 MΩ or higher

      If the result is not as specified, replace the generator rotor assembly.

  1. A097470E02
    Check the slip ring diameter.

    1. Using a vernier caliper, measure the slip ring diameter.

      Standard diameter:
      14.2 to 14.8 mm (0.559 to 0.583 in.)

      Minimum diameter:
      14 mm (0.551 in.)

      If the diameter is less than the minimum, replace the generator rotor assembly.


INSPECT GENERATOR DRIVE END FRAME BEARING

  1. A097471E01
    Check that the bearing is not rough or worn.

    OK:
    The bearing rotates smoothly.

    If the bearing does not rotate smoothly, replace the bearing.


INSPECT GENERATOR CLUTCH PULLEY (w/ Generator Clutch Pulley)

HINT:
Applicable only for models with generator clutch pulley.

  1. A192786E01
    Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.
    If the result is not as specified, replace the generator clutch pulley.

← INSPECTION (Jun 2006 – May 2009)REASSEMBLY (Jun 2006 – May 2009) →