REMOVAL
Removal / installation · Vehicles built from Jun 2006
| 2.
REMOVE FRONT FENDER APRON SEAL RH |
|
| 3.
REMOVE ENGINE UNDER COVER LH |
|
| 4.
REMOVE ENGINE UNDER COVER RH |
|
| 5.
REMOVE V-RIBBED BELT
|
 |
- Using SST and a 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the V-ribbed belt.
- SST
- 09216-42010
- NOTICE:
- Be sure to connect SST and the tools so that they are in line during use.
- When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
- After the tensioner is fully retracted, do not apply more force than necessary.
| 6.
REMOVE CRANKSHAFT PULLEY |
 |
- Using SST, hold the pulley in place and loosen the pulley bolt.
- SST
- 09213-54015
(91651-60855)
09330-00021
- Using SST, remove the pulley bolt and pulley.
- SST
- 09950-50013
(09951-05010, 09952-05010, 09953-05020, 09954-05021)
09950-40011
(09957-04010)
- HINT:
- If necessary, remove the pulley and pulley bolt using SST.
| 7.
REMOVE TIMING CHAIN CASE OIL SEAL |
 |
- Using a knife, cut off the oil seal lip.
Using a screwdriver with the tip taped, pry out the oil seal.
- NOTICE:
- After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.