2006-2011 Camry Aurion · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Jun 2006

HINT:
After installing the torsion bar, use your hand to open and close the luggage door. Make sure the luggage door can be opened and closed smoothly.


1. INSTALL LUGGAGE COMPARTMENT DOOR TORSION BAR SUPPORT

  1. B149080
    Install the luggage compartment door torsion bar support as shown in the illustration.


2. INSTALL LUGGAGE DOOR HINGE TORSION BAR LH

  1. B136875E01
    Set the tip of the luggage door hinge torsion bar LH in the center installation hole. The upper and lower installation holes are used for adjustment.

  1. B136816
    Connect the luggage door hinge torsion bar LH to the right side of the vehicle body as shown in the illustration.

  1. B149079
    Connect the luggage door hinge torsion bar LH to the luggage compartment door torsion bar support as shown in the illustration.

  1. B136812
    Using SST, install the luggage door hinge torsion bar LH to the luggage door hinge and the left side of the vehicle body as shown in the illustration.
    SST
    09804-24010  


3. INSTALL LUGGAGE DOOR HINGE TORSION BAR RH

  1. B136874E01
    Set the tip of the luggage door hinge torsion bar RH in the center installation hole. The upper and lower installation holes are used for adjustment.

  1. B136818
    Connect the luggage door hinge torsion bar RH to the left side of the vehicle body as shown in the illustration.

  1. B149077
    Connect the luggage door hinge torsion bar RH to the luggage compartment door torsion bar support as shown in the illustration.

  1. B136814
    Using SST, install the luggage door hinge torsion bar RH to the luggage door hinge and the right side of the vehicle body as shown in the illustration.
    SST
    09804-24010  


4. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER LH

  1. B149050
    Install the luggage compartment inner trim cover LH with the 2 clips.


5. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER RH

  1. B136855
    Install the luggage compartment inner trim cover RH with the 2 clips.


6. INSTALL REAR FLOOR FINISH PLATE

  1. B136852
    Engage the 7 clips and install the rear floor finish plate.


7. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

  1. B136879
    Install the 2 No. 1 luggage compartment trim hooks with the 2 screws.


8. INSTALL SPARE WHEEL COVER ASSEMBLY

9. INSTALL SPARE WHEEL COVER CLAMP

10. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
← REMOVAL (from Jun 2006)COMPONENTS (from Jun 2006) →