2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Oct 2006


INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

  1. E121512
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    5 - 4
    OFF
    10 kΩ or higher
    5 - 4
    ON
    Below 1 Ω

    If the result is not as specified, replace the hazard warning signal switch assembly.

  1. Apply battery voltage to the hazard warning signal switch assembly connector.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 7
    Battery negative (-) → Terminal 8
    Illumination comes on

    If the result is not as specified, replace the hazard warning signal switch assembly.

← REMOVAL (from Jun 2009)INSTALLATION (Oct 2006 – May 2009) →