2006-2011 Camry Aurion · Service Manual STEERING

REMOVAL

Removal / installation · Vehicles built from Jun 2006


1. DRAIN POWER STEERING FLUID

2. REMOVE FRONT WHEEL RH

3. REMOVE ENGINE UNDER COVER RH

4. REMOVE FRONT FENDER APRON SEAL RH

5. REMOVE V-RIBBED BELT

  1. A114351E03
    Using SST and a 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the V-ribbed belt.
    SST
    09216-42010  

    NOTICE:
    1. Be sure to connect SST and the tools so that they are in line during use.
    2. When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
    3. After the tensioner is fully retracted, do not apply more force than necessary.


6. DISCONNECT NO. 1 FLUID RESERVOIR TO PUMP HOSE

  1. C135224E02
    Slide the clip and disconnect the No. 1 fluid reservoir to pump hose from the vane pump assembly.


7. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for LHD)

  1. C135226
    Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.

  1. Remove the gasket from the pressure feed tube assembly.


8. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for RHD)

  1. C137088
    Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.

  1. Remove the gasket from the pressure feed tube assembly.


9. DISCONNECT POWER STEERING FLUID PRESSURE SWITCH CONNECTOR

  1. C135234
    Disconnect the power steering fluid pressure switch connector.


10. REMOVE VANE PUMP ASSEMBLY

  1. C135228E01
    Using SST, loosen the 2 bolts and remove the vane pump assembly.
    SST
    09249-63010  

  1. C135233
    Remove the 2 bolts from the vane pump assembly.

← COMPONENTS (from Jun 2006)DISASSEMBLY (from Jun 2006) →