DISASSEMBLY
Removal / installation · Vehicles built from Jun 2006
| 1.
HOLD VANE PUMP ASSEMBLY |
 |
- Using SST, hold the vane pump assembly in a vise.
- SST
- 09630-00014
(09631-00132)
| 2.
REMOVE POWER STEERING SUCTION PORT UNION |
 |
- Remove the bolt and power steering suction port union from the vane pump assembly.
Using a screwdriver, remove the O-ring from the power steering suction port union.
| 3.
REMOVE POWER STEERING FLUID PRESSURE SWITCH |
 |
- Remove the power steering fluid pressure switch from the vane pump assembly.
- NOTICE:
- Perform this procedure only when the power steering fluid pressure switch is replaced.
| 4.
REMOVE FLOW CONTROL VALVE ASSEMBLY |
 |
- Remove the pressure port union.
Remove the O-ring from the pressure port union.
Remove the flow control valve assembly and the flow control valve compression spring.
| 5.
REMOVE VANE PUMP REAR HOUSING |
 |
- Remove the 4 bolts and vane pump rear housing from the vane pump front housing.
- Using a screwdriver, remove the O-ring from the vane pump rear housing.
- HINT:
- Tape the screwdriver tip before use.
| 6.
REMOVE VANE PUMP SHAFT WITH PULLEY |
 |
- Using 2 screwdrivers, remove the vane pump shaft snap ring from the vane pump shaft with pulley.
Remove the vane pump shaft with pulley.
| 7.
REMOVE VANE PUMP ROTOR |
 |
- Remove the 10 vane pump plates.
Remove the vane pump rotor.
| 8.
REMOVE VANE PUMP CAM RING |
 |
- Remove the vane pump cam ring from the vane pump front housing.
| 9.
REMOVE VANE PUMP FRONT SIDE PLATE |
 |
- Remove the vane pump front side plate from the vane pump front housing.
- Using a screwdriver, remove the O-ring from the vane pump front side plate.
- HINT:
- Tape the screwdriver tip before use.
- Remove the O-ring from the vane pump front housing.
| 10.
REMOVE VANE PUMP HOUSING OIL SEAL |
 |
- Using a screwdriver and a shop rag or a piece of cloth, remove the vane pump housing oil seal.
- NOTICE:
- Be careful not to damage the vane pump front housing.