2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Combination Meter ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
Combination Meter ECU Communication Stop Mode
  1. "Combination Meter" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Combination Meter ECU Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the combination meter
  2. Combination meter main wire or connector
  3. Combination meter

HINT:
"Combination Meter" refers to the circuit that includes the combination meter.


WIRING DIAGRAM

C126214E13

INSPECTION PROCEDURE

NOTICE:
  1. Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN CAN NO. 1 BUS WIRE (COMBINATION METER MAIN BUS WIRE)

  1. C133243E01
    Turn the engine switch off.

  1. Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F1-17 (CANH) - F1-18 (CANL)
    Engine switch off
    108 to 132 Ω



NG
REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (COMBINATION METER MAIN BUS WIRE)
OK


2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

  1. C133243E02
    Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F1-24 (ES) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    F1-13 (IG+) - Body ground
    Engine switch on (IG)
    10 to 14 V
    F1-2 (B2) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY


← Main Body ECU Communication Stop Mode (from Oct 2006)Center Airbag Sensor Communication Stop Mode (from Oct 2006) →