Main Body ECU Communication Stop Mode
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| Main Body ECU Communication Stop Mode |
|
|
- HINT:
- "Main Body" refers to the circuit that includes the main body ECU.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
- After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.
- Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
- HINT:
- Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
| 1. CHECK FOR OPEN IN CAN NO. 1 BUS WIRE (MAIN BODY ECU BRANCH WIRE) |
Turn the engine switch off.

Disconnect the main body ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E8-5 (CANH) - E8-6 (CANL)
Engine switch off
54 to 69 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
Disconnect the IF J/B connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
IF-10 (GND1) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
IF-11 (IG) - Body ground
Engine switch on (IG)
10 to 14 V
Reconnect the main body ECU connectors.
|
|
||||
| OK | ||
| ||
