2006-2011 Camry Aurion · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

  1. B132119
    Disengage the claw and remove the sliding roof room light bracket.

  1. B125922
    Remove the 2 bolts and sliding roof drive gear sub-assembly.

    NOTICE:
    To prevent the sliding roof glass and sliding roof drive gear from being displaced, fully close the sliding roof glass (sliding roof drive cable), and then remove the sliding roof drive gear.


2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY

  1. B148824
    Remove the screw and sliding roof piece sub-assembly LH.

    HINT:
    Use the same procedure for the RH side and the LH side.

  1. B148825
    Slide and remove the sunshade trim sub-assembly.


3. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:
Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.

  1. B125928
    Remove the 2 screws and sliding roof side stoppers.

  1. B125930E02
    Using a screwdriver, disengage the 2 claws. Then slide the sliding roof drip channel rearward to remove it.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

    B139634E01

    HINT:
    Hold the window deflector down, as shown in the illustration, until the sliding roof drive cable sub-assembly becomes disengaged from the window deflector.

← REMOVAL (from Jun 2009)REASSEMBLY (from Jun 2006) →