2006-2011 Camry Aurion · Service Manual BODY

REASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

  1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.

    B139633E01

    NOTICE:
    Make sure that the spring indicated by the arrow in the illustration is securely installed.

    HINT:
    Hold the window deflector down, as shown in the illustration, until the sliding roof drive cable sub-assembly runs on the window deflector.

  1. B131978
    Engage the 2 claws and install the sliding roof drip channel.

  1. B125928
    Install the 2 sliding roof side stoppers with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }


2. ADJUST FULLY CLOSED POSITION

  1. B122196E01
    Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction as indicated by the arrows in the illustration and align the matchmarks.

    HINT:
    Tape the screwdriver tip before use.


3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY

  1. B148826
    Insert the sunshade trim into the sliding roof housing sub-assembly.

  1. B148824
    Install the sliding roof piece sub-assemblies LH and RH with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }


4. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

  1. B125922
    Install the sliding roof drive gear sub-assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. B132119
    Engage the claw and install the sliding roof room light bracket.

← DISASSEMBLY (from Jun 2006)INSTALLATION (Jun 2006 – Sep 2006) →