DISASSEMBLY
Removal / installation · Vehicles built Jun 2006 – Sep 2006
| 1. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY |
Release the 2 claws and remove the No. 2 air duct sub-assembly as shown in the illustration.

| 2. REMOVE COOLER EXPANSION VALVE |
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.

| 3. REMOVE BLOWER ASSEMBLY |
Remove the connector and clamp, and disconnect the wire harness.

Remove the 6 screws and then the blower assembly with the cooler evaporator sub-assembly.

| 4. REMOVE NO. 6 HEATER TO REGISTER DUCT ASSEMBLY |
Release the 4 claws and remove the No. 6 heater to register duct assembly.

| 5. REMOVE DRAIN COOLER HOSE |
Remove the drain cooler hose from the air conditioning radiator assembly.

| 6. REMOVE AIR OUTLET CONTROL SERVO MOTOR |
Disconnect the 2 connectors and remove the air conditioner harness.

Remove the 3 screws and then remove the air outlet control servo motor.

| 7. REMOVE AIR MIX CONTROL SERVO MOTOR (for Automatic Air Conditioning System) |
Remove the 2 screws and air mix control servo motor.

| 8. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY |
Remove the screw and clamp.

Release the 4 claws and remove the clamp.
Remove the heater radiator unit sub-assembly from the air conditioning radiator assembly.

- NOTICE:
- Prepare a drain pan or cloth in case the cooling coolant leaks.
| 9. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
Remove the clamp and No. 1 cooler thermistor.

Remove the No. 1 cooler evaporator sub-assembly.

Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.

