2006-2011 Camry Aurion · Service Manual HEATER & AIR CONDITIONING SYSTEM

REASSEMBLY

Removal / installation · Vehicles built Jun 2006 – Sep 2006


1. INSTALL NO. 1 COOLER THERMISTOR

  1. If using a new evaporator:

    1. C129887E03
      Install the No. 1 cooler thermistor to the evaporator as shown in the illustration.

  1. If reusing the evaporator:

    1. C129888E01
      Install the No. 1 cooler thermistor to the evaporator as shown in the illustration.


2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

  1. C129881
    Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces. Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. C129880
    Install the No. 1 cooler evaporator sub-assembly.


3. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY

  1. E128528
    Install the heater radiator unit sub-assembly to the air conditioner radiator assembly.

  1. C129730
    Install the clamp with the screw.

  1. Engage the 4 claws and install the heater clamp.


4. INSTALL AIR MIX CONTROL SERVO MOTOR (for Automatic Air Conditioning System)

  1. C129729
    Install the air mix control servo motor with the 2 screws.


5. INSTALL AIR OUTLET CONTROL SERVO MOTOR

  1. C129728
    Install the air outlet control servo motor with the 3 screws.

  1. C129727
    Connect the 2 connectors and install the air conditioner harness.


6. INSTALL DRAIN COOLER HOSE

  1. E128535
    Install the drain cooler hose to the air conditioner radiator assembly.


7. INSTALL NO. 6 HEATER TO REGISTER DUCT ASSEMBLY

  1. E128525
    Engage the 4 claws to install the No. 6 heater to register duct assembly.


8. INSTALL BLOWER ASSEMBLY

  1. E129997
    Install the blower assembly with the 6 screws.

  1. E129996
    Connect the connector.


9. INSTALL COOLER EXPANSION VALVE

  1. C129879
    Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 35 kgf*cm , 30 in.*lbf }


10. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY

  1. E129155
    Engage the 2 claws to install the No. 2 air duct sub-assembly.

← DISASSEMBLY (Jun 2006 – Sep 2006)INSTALLATION (Jun 2006 – Sep 2006) →