Door Key Lock / Unlock Switch Circuit
Circuit diagnosis · Vehicles built from Jun 2006
DESCRIPTION
The door lock and unlock switch is built into the front passenger door lock assembly.This switch is ON when the door key is in the unlock position and OFF when the door key is in the lock position. It is used as one of the operating conditions for the key confinement prevention function.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FRONT DOOR LOCK ASSEMBLY RH (DOOR KEY LOCK AND UNLOCK SWITCH) |
Remove the front door lock assembly RH.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
5 - 8
ON
(Door lock set to UNLOCK)
Below 1 Ω
5 - 8
6 - 8
OFF (Free)
10 kΩ or higher
6 - 8
ON
(Door lock set to LOCK)
Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (FRONT DOOR LOCK RH - MAIN BODY ECU (INSTRUMENT PANEL J/B)) |
Disconnect the IJ J/B connector.


Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection (Symbols)
Condition
Specified Condition
H8-6 (L) - IJ-5
Always
Below 1 Ω
H8-5 (UL) - IK-7
Always
Below 1 Ω
H8-8 (E) - Body ground
Always
Below 1 Ω
H8-6 (L) - Body ground
Always
10 kΩ or higher
H8-5 (UL) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
