Luggage Compartment Door Lock Circuit
Circuit diagnosis · Vehicles built from Jun 2006
DESCRIPTION
The luggage compartment door lock motor is built into the luggage compartment door lock assembly.The main body ECU receives a luggage compartment door unlock signal from the luggage compartment door lock cylinder and operates the door unlock motor.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST (LUGGAGE COMPARTMENT DOOR) |
Select the ACTIVE TEST, use the intelligent tester to generate a control command, and then check that the door lock operates.
Main Body: Tester Display
Test Part
Control Range
Diagnostic Note
Trunk and Back-Door Open
Operate luggage compartment door lock motor
UNLOCK (OPEN)
-
- OK:
- Luggage compartment door lock is opened.
|
|
||||
| OK | ||
| ||
| 2. INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY (DOOR LOCK MOTOR) |
Remove the luggage compartment door lock assembly.

Apply battery voltage and check operation of the door lock motor.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Unlock
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (LUGGAGE COMPARTMENT DOOR LOCK - MAIN BODY ECU) |
Disconnect the ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection (Symbols)
Condition
Specified Condition
E7-1 (TR+) - S5-1
Always
Below 1 Ω
S5-1 - Body ground
Always
10 kΩ or higher
S5-2 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
