2006-2011 Camry Aurion · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. DRAIN ENGINE COOLANT

2. REMOVE ENGINE UNDER COVER RH

3. REMOVE ENGINE UNDER COVER LH

4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A144946E01
    Disconnect the mass air flow meter connector (*1).

  1. Disconnect the purge VSV connector (*2).

  1. Disconnect the 2 purge VSV vacuum hoses (*3).

  1. Disconnect the purge line hose from the clamp (*4).

  1. A146036
    Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. A135668
    Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.

  1. A146037
    Remove the 2 bolts and air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


5. REMOVE AIR CLEANER INLET ASSEMBLY

  1. A134903
    Remove the 2 bolts, clamp and air cleaner inlet.


6. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)

  1. B150435E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B150437
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B150439
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each connector, and then remove the front bumper assembly.


7. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)

  1. B150434E01
    Put protective tape around the front bumper assembly.

  1. B138884E01
    Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B150436
    Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.

  1. B150438
    Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the front bumper assembly.


8. REMOVE FRONT BUMPER ENERGY ABSORBER

  1. B150451
    Remove the front bumper energy absorber from the front bumper reinforcement sub-assembly.


9. SEPARATE RADIATOR RESERVOIR TANK HOSE

  1. A135233
    Separate the radiator reserve tank hose from the radiator assembly.


10. DISCONNECT RADIATOR HOSE INLET

  1. A146041
    Disconnect the radiator hose inlet from the radiator assembly.


11. DISCONNECT RADIATOR HOSE OUTLET

  1. A133364
    Disconnect the radiator hose outlet from the radiator assembly.


12. DISCONNECT OIL COOLER INLET HOSE (for Automatic Transaxle)

  1. A133365
    Disconnect the oil cooler inlet hose from the radiator assembly.


13. DISCONNECT OIL COOLER OUTLET HOSE (for Automatic Transaxle)

  1. A133366
    Disconnect the oil cooler outlet hose from the radiator assembly.


14. REMOVE HOOD LOCK ASSEMBLY (for LHD)

  1. B149051
    Remove the 3 bolts.

  1. B136827
    Disconnect the hood lock control cable.

  1. Remove the hood lock assembly.


15. REMOVE HOOD LOCK ASSEMBLY (for RHD)

  1. B149052
    Disconnect the connector.

  1. Remove the 3 bolts.

  1. B149053
    Disconnect the hood lock control cable.

  1. Remove the hood lock assembly.


16. REMOVE RADIATOR SUPPORT UPPER
  1. Remove the clamp and separate the hood lock control cable from the radiator support upper.

  1. A145802
    Remove the 5 bolts and radiator support upper.


17. REMOVE RADIATOR ASSEMBLY

  1. A135241
    Remove the 3 clamps and disconnect the 2 connectors.

  1. A135239
    Remove the 4 bolts and separate the condenser assembly from the radiator assembly.

  1. A135238
    Remove the radiator assembly from the body.


18. REMOVE FAN ASSEMBLY WITH MOTOR

  1. A143820E01
    Release the 3 snap fits and lift the fan assembly with motor from the radiator.


19. REMOVE RADIATOR SUPPORT CUSHION

  1. A133371E02
    Remove the 2 radiator support cushions from the radiator assembly.


20. REMOVE RADIATOR SUPPORT LOWER

  1. A133371E03
    Remove the 2 radiator support lowers from the radiator assembly.

← REMOVAL (Jun 2006 – Sep 2006)REMOVAL (from Jun 2009) →