Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Remove the radiator cap sub-assembly from the radiator assembly.
Loosen the radiator drain cock plug and cylinder block drain cock plug, then drain the coolant.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
2.
REMOVE ENGINE UNDER COVER RH
3.
REMOVE ENGINE UNDER COVER LH
4.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Disconnect the mass air flow meter connector (*1).
Disconnect the purge VSV connector (*2).
Disconnect the 2 purge VSV vacuum hoses (*3).
Disconnect the purge line hose from the clamp (*4).
Disconnect the No. 2 ventilation hose from the air cleaner hose.
Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.
Remove the 2 bolts and air cleaner cap.
Remove the air cleaner filter element from the air cleaner case.
5.
REMOVE AIR CLEANER INLET ASSEMBLY
Remove the 2 bolts, clamp and air cleaner inlet.
6.
REMOVE FRONT BUMPER ASSEMBLY
Put protective tape around the front bumper assembly.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
HINT:
Use the same procedure for the RH side and LH side.
Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
HINT:
Use the same procedure for the RH side and LH side.
w/o Fog Light:
Remove the front bumper assembly.
w/ Fog Light:
Disconnect each connector, and then remove the front bumper assembly.
7.
REMOVE FRONT BUMPER ENERGY ABSORBER
Disengage the 2 guides and remove the front bumper energy absorber from the front bumper reinforcement sub-assembly.
8.
SEPARATE RADIATOR RESERVOIR TANK HOSE
Separate the radiator reserve tank hose from the radiator assembly.
9.
DISCONNECT RADIATOR HOSE INLET
Disconnect the radiator hose inlet from the radiator assembly.
10.
DISCONNECT RADIATOR HOSE OUTLET
Disconnect the radiator hose outlet from the radiator assembly.