DISASSEMBLY
Removal / installation · Vehicles built from Jun 2006
| 1.
REMOVE DRAIN PLUG |
 |
Remove the drain plug.
Remove the O-ring.
| 2.
REMOVE RADIATOR TANK UPPER |
 |
- Install the claw to the overhaul handle, inserting it in the hole in part A as shown in the illustration.
- SST
- 09230-01010
(09231-01010, 09231-01030)
While gripping the handle, adjust the stopper bolt so that dimension B is as shown in the illustration.
- Dimension B:
- 0.2 to 0.3 mm (0.008 to 0.012 in.)
- NOTICE:
- If the stopper bolt is not adjusted, the claw may be damaged.
- Using SST to release the caulking, grip the handle until stopped by the stopper bolt.
- SST
- 09230-01010
(09231-01010, 09231-01030)
- Lightly tap the bracket of the radiator (or radiator hose inlet or outlet) with a soft-faced hammer and remove the tank.
Remove the O-ring.
| 3.
REMOVE RADIATOR TANK LOWER |
 |
- Remove the bolt, 2 clips and hose from the radiator assembly.
Removal procedure of the radiator tank lower is the same as that of the radiator tank upper.