INSTALLATION
Removal / installation · Vehicles built from Oct 2006
| 1. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE |
Install a new gasket to the fuel suction tube.

Install the fuel suction tube.
- NOTICE:
- Do not damage the fuel pump filter.
- Be careful that the arm of the sender gauge does not bend.
- Do not damage the fuel pump filter.
| 2. INSTALL FUEL TANK VENT TUBE SET PLATE |
Align the mark of the set plate with the fuel suction tube.

Install the set plate with the 8 bolts.
- Torque:
- 5.9 N*m{ 60 kgf*cm , 52 in.*lbf }
| 3. CONNECT FUEL PUMP TUBE SUB-ASSEMBLY |
Install the fuel pump tube with the tube joint clip.

- NOTICE:
- Check that there are no scratches or foreign objects on the connecting part.
- Check that the fuel tube joint is inserted securely.
- Check that the tube joint clip is on the collar of the fuel tube joint.
- After installing the tube joint clip, check that the fuel tube joint cannot be pulled off.
- Check that there are no scratches or foreign objects on the connecting part.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. INSPECT FOR FUEL LEAK |
- HINT:
- Click here.
| 6. INSTALL REAR FLOOR SERVICE HOLE COVER |
Connect the fuel pump connector.

Install the rear floor service hole cover with new butyl tape.
| 7. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) |
Attach the front hooks of the bench type rear seat cushion assembly to the vehicle body.

Confirm that the seat cushion is firmly installed.
- NOTICE:
- When installing the bench type rear seat cushion assembly, make sure that the seat belt buckle is not under the bench type rear seat cushion assembly.
| 8. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type) |
Attach the 2 front hooks of the seat cushion to the vehicle body.

Confirm that the seat cushion is firmly installed.
- NOTICE:
- When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.
