2006-2011 Camry Aurion · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. INSTALL REAR EXHAUST PIPE NO. 1 SUPPORT BRACKET

  1. A060823E05
    Install the rear support bracket with the 2 bolts.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }

    NOTICE:
    Be sure to install the bracket in the correct direction.


2. INSTALL HEATED OXYGEN SENSOR (for Bank 2)

  1. A144643E02
    Using SST, install the heated oxygen sensor.
    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

    NOTICE:
    The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (Click here).


3. INSTALL HEATED OXYGEN SENSOR (for Bank 1)

  1. A144644E02
    Using SST, install the heated oxygen sensor.
    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

    NOTICE:
    The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (Click here).


4. INSTALL EXHAUST FRONT PIPE ASSEMBLY
  1. Install 2 new gaskets to the exhaust front pipe.

  1. Install the exhaust front pipe to the exhaust manifolds with the 2 nuts and 2 bolts.

    A146046

    Torque:
    62 N*m{ 632 kgf*cm , 46 ft.*lbf }


5. INSTALL FRONT EXHAUST PIPE NO. 1 SUPPORT BRACKET

  1. A085549E01
    Install the front support brackets with the 2 nuts.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }

    NOTICE:
    Be sure to install the support brackets in the correct direction.


6. INSTALL CENTER EXHAUST PIPE ASSEMBLY
  1. Install a new gasket to the center exhaust pipe assembly.

  1. Install the center exhaust pipe to the exhaust front pipe with the 2 nuts and 2 bolts.

    A146045

    Torque:
    56 N*m{ 571 kgf*cm , 41 ft.*lbf }


7. INSTALL EXHAUST TAIL PIPE ASSEMBLY
  1. Install 2 new gaskets to the exhaust tail pipes.

  1. Install the 2 exhaust tail pipes with the 4 nuts.

    A146044

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }


8. INSPECT FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace the damaged parts as necessary.
← INSTALLATION (Oct 2006 – May 2009)ON-VEHICLE INSPECTION (from Jun 2006) →