2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


REMOVE REAR WHEEL

SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

  1. C083014E02
    Remove the bolt and separate the flexible hose from the shock absorber.

  1. C224315E01
    Remove the 2 bolts and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.


REMOVE REAR DISC

  1. C132813E01
    Put matchmarks on the rear disc and the axle hub.

  1. C131914E02
    Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn and press the shoe adjuster firmly until the wheel comes free.


INSPECT REAR AXLE HUB BEARING LOOSENESS

  1. C224308E01
    Using a dial indicator, check for looseness near the center of the axle hub.

    Maximum:
    0.05 mm (0.0020 in.)

    NOTICE:
    Ensure that the dial indicator is set perpendicular to the measurement surface.

    If looseness exceeds the maximum, replace the axle hub assembly.


INSPECT REAR AXLE HUB RUNOUT

  1. C224310E01
    Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

    Maximum:
    0.07 mm (0.0027 in.)

    NOTICE:
    Ensure that the dial indicator is set perpendicular to the measurement surface.

    If runout exceeds the maximum, replace the axle hub assembly.


INSTALL REAR DISC

  1. C132813E01
    Aligning the matchmarks, install the rear disc.

    HINT:
    When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.


INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

  1. C224315E01
    Install the rear disc brake caliper with the 2 bolts.

    Torque:
    for LHD:
    62 N*m{ 632 kgf*cm , 46 ft.*lbf }
    for RHD:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }

    NOTICE:
    Do not twist the brake hose when installing the rear disc brake caliper assembly LH.

  1. C083014E03
    Install the rear flexible hose with the bolt.

    Torque:
    19 N*m{ 192 kgf*cm , 14 ft.*lbf }


INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }

← COMPONENTS (from Jun 2009)ON-VEHICLE INSPECTION (Oct 2006 – May 2009) →