ON-VEHICLE INSPECTION
Inspection · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
|
 |
- Remove the bolt and separate the flexible hose from the shock absorber.
- Remove the 2 bolts and separate the rear disc brake caliper assembly.
- NOTICE:
- Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
| REMOVE REAR DISC
|
 |
- Put matchmarks on the rear disc and the axle hub.
- Release the parking brake and remove the rear disc.
- HINT:
- If the disc cannot be removed easily, turn and press the shoe adjuster firmly until the wheel comes free.
| INSPECT REAR AXLE HUB BEARING LOOSENESS |
 |
- Using a dial indicator, check for looseness near the center of the axle hub.
- Maximum:
- 0.05 mm (0.0020 in.)
- NOTICE:
- Ensure that the dial indicator is set perpendicular to the measurement surface.
If looseness exceeds the maximum, replace the axle hub assembly.
| INSPECT REAR AXLE HUB RUNOUT |
 |
- Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
- Maximum:
- 0.07 mm (0.0027 in.)
- NOTICE:
- Ensure that the dial indicator is set perpendicular to the measurement surface.
If runout exceeds the maximum, replace the axle hub assembly.
| INSTALL REAR DISC
|
 |
- Aligning the matchmarks, install the rear disc.
- HINT:
- When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.
| INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
|
 |
- Install the rear disc brake caliper with the 2 bolts.
-
Torque:
- for LHD:
- 62 N*m{
632 kgf*cm
, 46 ft.*lbf
}
- for RHD:
- 47 N*m{
479 kgf*cm
, 35 ft.*lbf
}
- NOTICE:
- Do not twist the brake hose when installing the rear disc brake caliper assembly LH.
- Install the rear flexible hose with the bolt.
-
Torque:
- 19 N*m{
192 kgf*cm
, 14 ft.*lbf
}
| INSTALL REAR WHEEL |
 |
-
Torque:
- 103 N*m{
1,050 kgf*cm
, 76 ft.*lbf
}