PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
If a normal code is displayed during the DTC check but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.
- NOTICE:
- When replacing the skid control ECU, sensor, etc., turn the ignition switch off.
- HINT:
- Inspect the fuses and relays before investigating the suspected areas as shown in the table below.
- Inspect each malfunction circuit in numerical order for the corresponding symptoms.
- Inspect the fuses and relays before investigating the suspected areas as shown in the table below.
| Symptom |
Suspected Area |
See page |
| ABS does not operate |
1. Check the DTC reconfirming that the normal system code is output. |
Click here
|
| 2. IG power source circuit |
Click here
|
|
| 3. Front speed sensor circuit |
Click here
|
|
| 4. Rear speed sensor circuit |
Click here
|
|
| 5. Check the brake actuator assembly with the intelligent tester (Check brake actuator assembly operation using the active test function). If abnormal, check the hydraulic circuit for leakage. |
Click here
|
|
| 6. If the symptoms still occur after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). |
Click here
|
|
| ABS does not operate efficiently |
1. Check the DTC reconfirming that the normal system code is output. |
Click here
|
| 2. Front speed sensor circuit |
Click here
|
|
| 3. Rear speed sensor circuit |
Click here
|
|
| 4. Stop light switch circuit |
Click here
|
|
| 5. Check the brake actuator assembly with the intelligent tester (Check brake actuator assembly operation using the active test function). |
Click here
|
|
| 6. If the symptoms still occur after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). |
Click here
|
|
| ABS warning light malfunction (Remains on) |
1. Check DTC |
Click here
|
| 2. ABS warning light circuit |
Click here
|
|
| ABS warning light malfunction (Does not come on) |
1. ABS warning light circuit |
Click here
|
| Brake warning light malfunction (Remains on) |
1. Check DTC |
Click here
|
| 2. Brake warning light circuit |
Click here
|
|
| Brake warning light malfunction (Does not come on) |
1. Brake warning light circuit |
Click here
|
| ABS sensor DTC check cannot be done |
1. Check the DTC reconfirming that the normal system code is output. |
Click here
|
| 2. TS and CG terminal circuit |
Click here
|
|
| 3. TC and CG terminal circuit |
Click here
|
|
| 4. If the symptoms still occur after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). |
Click here
|