The skid control ECU sends the indicator signals to the combination meter assembly via the CAN communication system. If any of the following is detected, the ABS warning light remains on.
The skid control ECU connectors are disconnected from the skid control ECU.
There is a malfunction in the skid control ECU internal circuit.
There is an open in the wire harness between the combination meter and the skid control ECU.
The ABS and/or EBD is defective.
HINT:
The intelligent tester may not be used when the skid control ECU is abnormal.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
Check the condition of each related circuit before troubleshooting (Click here).
1. INSPECT CAN COMMUNICATION SYSTEM
Check if a CAN communication system DTC is output (Click here).
Result:
Condition
Proceed to
CAN communication system DTC is not output
A
CAN communication system DTC is output
B
B
INSPECT CAN COMMUNICATION SYSTEM
A
2. CHECK SKID CONTROL ECU CONNECTOR SECURELY CONNECTED
Check if the skid control ECU connector is connected.
OK:
The connector is securely connected.
NG
CONNECT CONNECTOR TO ECU CORRECTLY
OK
3. CHECK BATTERY
Check the battery voltage.
Standard voltage:
11 to 14 V
NG
INSPECT CHARGING SYSTEM
OK
4. INSPECT SKID CONTROL ECU CONNECTOR (IG1 TERMINAL VOLTAGE)
Disconnect the skid control ECU connector.
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
Standard voltage:
Tester Connection
Condition
Specified Condition
A25-18 (IG1) - Body ground
Ignition switch ON
10 to 14 V
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (IG1 CIRCUIT)
OK
5. INSPECT SKID CONTROL ECU CONNECTOR (GND TERMINAL CONTINUITY)
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Specified Condition
A25-4 (GND1) - Body ground
Below 1 Ω
A25-1 (GND2) - Body ground
Below 1 Ω
Connect the connector.
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK
6. INSPECT COMBINATION METER ASSEMBLY
Connect the intelligent tester to the DLC3.
Select the "Active Test" on the tester (Click here).
Active Test: ABS
Tester Display
Test Part
Control Range
Diagnostic Note
ABS Warning Lamp
ABS warning light
Warning light ON / OFF
Observe combination meter
Check the ABS warning light operation.
OK:
The ABS warning light turns on or off in accordance with the intelligent tester.