2006-2011 Camry Aurion · Service Manual BRAKE

ABS Warning Light does not Come ON

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

WIRING DIAGRAM

C145720E01

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).


1. INSPECT CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Condition
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
REPAIR CAN COMMUNICATION SYSTEM (Click here)
A


2. INSPECT ABS WARNING LIGHT

HINT:
When disconnecting the skid control ECU connector, the ABS warning light comes on.

  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to the ON position.

  1. Check that the ABS warning light comes on.

    OK:
    The ABS warning light comes on.

  1. Connect the connector.



NG
Go to step 3
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)

3. INSPECT COMBINATION METER ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Select the "Active Test" on the tester (Click here).

    Active Test: ABS 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    ABS Warning Lamp
    ABS warning light
    Warning light ON/OFF
    Observe combination meter

  1. Check the ABS warning light operation.

    OK:
    The ABS warning light turns on or off in accordance with the intelligent tester.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← ABS Warning Light Remains ON (from Jun 2009)ABS Warning Light does not Come ON (Oct 2006 – May 2009) →