2006-2011 Camry Aurion · Service Manual ENGINE

B2281 "P" Signal Malfunction

Diagnostic trouble codes · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The ECM and the shift lock control ECU are connected by a cable and the CAN. If the cable information and CAN information are inconsistent, this DTC will be output.

HINT:
After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.

DTC No.
DTC Detection Condition
Trouble Area
B2281
Cable information and CAN information between main body ECU and shift lock control ECU are inconsistent
  1. Main body ECU
  2. Shift lock control ECU
  3. Wire harness or connector

WIRING DIAGRAM

B157544E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the intelligent tester main switch on.

  1. Read the DATA LIST according to the displays on the tester.

    Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Shift P Sig
    Shift P Signal / ON or OFF
    ON: Shift P signal ON (Shift position is P)
    OFF: Shift P signal OFF (Shift position is not P)
    -

    OK:
    "ON" (P signal is ON) and "OFF" (P signal is OFF) appear on the screen.

    HINT:
    If the result is not as specified, there may be a malfunction with the shift lock control ECU (Click here).



NG
GO TO SHIFT CONTROL SYSTEM
OK


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SHIFT LOCK CONTROL ECU)

  1. Disconnect the E9 and E57 ECU connectors.B138006E04

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E9-2 (P) - E57-11 (P2)
    Always
    Below 1 Ω
    E9-2 (P) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK MAIN BODY ECU OPERATION
  1. After replacing the main body ECU with a normally functioning ECU, check that the engine can start normally. Make sure the brake pedal is depressed and the shift position is P at this time.

  1. Check that the engine switch mode can be changed by pushed the engine switch.

    HINT:
    Without depressing the brake pedal, push the engine switch repeatedly. Engine switch mode should turn from off to on (ACC) to on (IG) and back to off. With the brake pedal depressed, push the engine switch repeatedly. Engine switch mode should turn to ENGINE START from any status.

    OK:
    Engine can start normally.

    HINT:
    If engine does not start (Click here).



NG
GO TO SHIFT CONTROL SYSTEM
OK

END (MAIN BODY ECU DEFECTIVE)


← B2281 "P" Signal Malfunction (Oct 2006 – May 2009)B2282 Vehicle Speed Signal Malfunction (+ B2283) (Oct 2006 – May 2009) →