HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
*: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Interview the customer to confirm the trouble.
| |||||
| 3.CHECK CAN COMMUNICATION SYSTEM* |
Check for DTCs (Click here).
- HINT:
- The skid control ECU is connected to the CAN communication system.
- Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
- Result:
Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 4.CHECK DTC AND FREEZE FRAME DATA* |
Check for DTCs and Freeze Frame Data (Click here for DTC Check / Clear, Click here for Freeze Frame Data).
Record the DTCs and Freeze Frame Data.
Clear the DTCs.
Recheck for DTCs.
Reproduce the malfunction and check if the DTCs are output again.
- Result:
Result
Proceed to
DTC is output
A
DTC is not output (Problem symptom does not occur)
B
DTC is not output (Problem symptom occurs)
C
|
|||||
|
|||||
| |||||
| 5.DIAGNOSTIC TROUBLE CODE CHART |
Go to "DIAGNOSTIC TROUBLE CODE CHART" (Click here).
| |||||
| 6.CIRCUIT INSPECTION* |
| |||||
| 7.REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
| |||||
| 9.SYMPTOM SIMULATION |
| |||||
| 10.PROBLEM SYMPTOMS TABLE |
Go to "PROBLEM SYMPTOMS TABLE" (Click here).
| |||||
| 11.CIRCUIT INSPECTION* |
| |||||
| 12.REPAIR OR REPLACE |
| |||||
| 13.CONFIRMATION TEST |
| |||||