DTC CHECK / CLEAR
Troubleshooting · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE:) |
DTC check
Using SST, connect terminals TC and CG of the DLC3.

- SST
- 09843-18040
Turn the ignition switch on (IG).
Observe the blinking pattern of the ABS warning and SLIP indicator lights in order to identify the DTC.
- HINT:
- If no code appears, inspect the TC and CG terminal circuit and the ABS warning and SLIP indicator light circuit.
Trouble Area
See procedure
ABS warning light (Remains on)
Click here
ABS warning light (Does not come on)
Click here
SLIP indicator light (Remains on)
Click here
SLIP indicator light (Does not come on)
Click here
TC and CG terminal circuit
Click here
Count the number of blinks of the ABS warning and slip indicator lights.
- HINT:
- How read DTCs:
Diagnostic trouble codes are represented by the number of blinks of a warning light. For example, code 21 would be shown by 2 blinks, a pause of 1.5 seconds, and then 1 blink.
- If one code is detected:
The light repeats the same code after a pause of 4 seconds.
- If multiple code are detected:
The light outputs one code after another with a 2.5-second pause between each code.
When all codes have been output, there is a 4-second pause and then the light begins to output the codes again.
- The ABS warning and slip indicator lights do not indicate a normal system code.
- How read DTCs:
Codes are explained in the code table (Click here).
After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.
DTC clear
Using SST, connect terminals TC and CG of the DLC3.

- SST
- 09843-18040
Turn the ignition switch on (IG).
Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

Check that the warning light indicates a normal system code.
Remove the SST.
- HINT:
- Clearing the DTCs cannot be performed by disconnecting the battery terminal or the ECU-IG fuse.
| DTC CHECK/CLEAR (WHEN USING INTELLIGENT TESTER:) |
DTC check
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Read the DTCs by following the prompts on the tester screen.
DTC clear
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Operate the intelligent tester to clear the codes.
- HINT:
- Refer to the intelligent tester operator's manual for further details.
| END OF DTC CHECK/CLEAR |
Turn the ignition switch on (IG).
Check that the ABS warning and SLIP indicator lights go off within approximately 3 seconds.