2006-2011 Camry Aurion · Service Manual BRAKE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE:)

  1. DTC check

    1. G022986E01
      Using SST, connect terminals TC and CG of the DLC3.
      SST
      09843-18040  

    2. Turn the ignition switch to the ON position.

    3. Observe the blinking pattern of the ABS and VSC warning lights in order to identify the DTC.
      C146762E01

      HINT:
      If no code appears, inspect the TC and CG terminal circuit, the ABS warning light circuit, and the VSC warning light circuit.

      Trouble Area
      See procedure
      ABS warning light (Remains on)
      Click here
      ABS warning light (Does not come on)
      Click here
      VSC warning light (Remains on)
      Click here
      VSC warning light (Does not come on)
      Click here
      TC and CG terminal circuit
      Click here
      1. As an example, the blinking patterns for a normal system code and trouble codes 11 and 21 are shown in the illustration.

    4. Codes are explained in the code table (Click here).

    5. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

  2. DTC clear

    1. G022986E01
      Using SST, connect terminals TC and CG of the DLC3.
      SST
      09843-18040  

    2. Turn the ignition switch to the ON position.

    3. BR03890
      Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

    4. Check that the warning light indicates a normal system code.

    5. Remove the SST.

      HINT:
      Clearing the DTCs cannot be performed by disconnecting the battery terminal or the ECU-IG fuse.


DTC CHECK/CLEAR (WHEN USING INTELLIGENT TESTER:)

  1. DTC check

    1. C131976E01
      Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Read the DTCs by following the prompts on the tester screen.

  2. DTC clear

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Operate the intelligent tester to clear the codes.

      HINT:
      Refer to the intelligent tester operator's manual for further details.


END OF DTC CHECK/CLEAR
  1. Turn the ignition switch to the ON position.

  2. Check that the ABS warning light goes off within approximately 3 seconds.

← DIAGNOSIS SYSTEM (from Jun 2009)DTC CHECK / CLEAR (Oct 2006 – May 2009) →