2006-2011 Camry Aurion · Service Manual BRAKE

C1300/62 Skid Control ECU Malfunction

Diagnostic trouble codes · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The skid control ECU is housed in the brake actuator assembly.
The skid control ECU judges the vehicle driving condition based on the signals from each sensor, and controls the brake actuator assembly.
DTC No.
DTC Detection Condition
Trouble Area
C1300/62
Internal failure of the skid control ECU control unit
Brake actuator assembly (skid control ECU)

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).


1. CHECK DTC
  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC C1300/62 is output (only C1300/62)
    A
    Other DTCs are output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2. INSPECT SKID CONTROL ECU (IG1 TERMINAL VOLTAGE)

  1. C136493E16
    Disconnect the skid control ECU connector.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A26-28 (IG1) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (IG1 CIRCUIT)
OK


3. INSPECT SKID CONTROL ECU (GND TERMINAL CONTINUITY)

  1. C136493E13
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    A26-4 (GND1) - Body ground
    Below 1 Ω
    A26-1 (GND2) - Body ground
    Below 1 Ω

  1. Connect the connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← C1300/62 Skid Control ECU Malfunction (Oct 2006 – May 2009)U0073/94 Control Module Communication Bus OFF (+ U0100/65, U0123/62, U0126/63) (Jun 2006 – Sep 2006) →