DISASSEMBLY
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1.
REMOVE GENERATOR CLUTCH PULLEY |
 |
- Using a screwdriver, remove the generator pulley cap.
- Set SST (A) and (B).
- SST
- 09820-63020
Clamp SST (A) in a vise.
- Place the rotor shaft end into SST (A).
- Fit SST (B) to the clutch pulley.
- Loosen the pulley by turning SST (B) in the direction shown in the illustration.
Remove the generator assembly from the SST.
Remove the clutch pulley from the rotor shaft.
| 2.
REMOVE GENERATOR REAR END COVER |
 |
- Place the generator assembly on the clutch pulley.
- Remove the 3 nuts and generator rear end cover.
| 3.
REMOVE GENERATOR TERMINAL INSULATOR |
 |
- Remove the terminal insulator from the generator coil.
| 4.
REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
 |
- Remove the 2 screws and brush holder from the generator coil.
| 5.
REMOVE GENERATOR COIL ASSEMBLY |
 |
- Remove the 4 bolts.
- Using SST, remove the generator coil assembly.
- SST
- 09950-40011
(09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
| 6.
REMOVE GENERATOR ROTOR ASSEMBLY |
 |
- Remove the generator washer.
- Remove the generator rotor assembly.
| 7.
REMOVE GENERATOR DRIVE END FRAME BEARING |
 |
- Remove the 4 screws and retainer plate from the drive end frame.
- Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.
- SST
- 09950-60010
(09951-00250)
09950-70010
(09951-07100)