2006-2011 Camry Aurion · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE GENERATOR REAR END COVER

  1. A128071
    Remove the 3 nuts and generator rear end cover.


2. REMOVE GENERATOR TERMINAL INSULATOR

  1. A128072
    Remove the terminal insulator from the generator coil.


3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A128073
    Remove the 2 screws and brush holder assembly from the generator coil.


4. REMOVE GENERATOR COIL ASSEMBLY

  1. A128074
    Remove the 4 bolts.

  1. A118275E03
    Using SST, remove the generator coil assembly.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)


5. REMOVE GENERATOR CLUTCH PULLEY

  1. A215198
    Using a screwdriver, puncture the center of the generator pulley cap and pry it off.

    NOTICE:
    Do not reuse the generator pulley cap.

  1. Mount the generator drive end frame in a vise tightly.

  1. A128069E02
    Confirm SST (A) and (B) shown in the illustration.
    SST
    09820-63021  

  1. A185232E01
    Place SST (A) onto the rotor shaft end.

  1. A185233E01
    Fit SST (B) to the clutch pulley.

  1. A194274E03
    Loosen the pulley by turning SST (B) in the direction shown in the illustration.

    NOTICE:
    1. Check that the drive end frame is secured in the vise tightly.
    2. Hold SST (A) tightly during the operation.

  1. Remove the generator assembly from SST.

  1. Remove the clutch pulley from the rotor shaft.


6. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A118365E01
    Remove the generator washer.

  1. A220954E01
    Remove the generator rotor assembly.


7. REMOVE GENERATOR DRIVE END FRAME BEARING

  1. A128076
    Remove the 4 screws and bearing retainer from the drive end frame.

  1. A128077E01
    Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

← DISASSEMBLY (Oct 2006 – May 2009)INSPECTION (Oct 2006 – May 2009) →