REASSEMBLY
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL GENERATOR DRIVE END FRAME BEARING |
 |
- Using SST and a press, press in a new generator drive end frame bearing.
- SST
- 09950-60010
(09951-00470)
09950-70010
(09951-07100)
- Fit the tabs on the retainer plate into the cutouts on the drive end frame to install the retainer plate.
Install the 4 screws.
-
Torque:
- 2.3 N*m{
23 kgf*cm
, 20 in.*lbf
}
| 2.
INSTALL GENERATOR ROTOR ASSEMBLY |
 |
Place the drive end frame on the clutch pulley.
- Install the generator rotor assembly to the drive end frame.
- Place a new generator washer on the generator rotor.
| 3.
INSTALL GENERATOR COIL ASSEMBLY |
 |
- Using a deep socket wrench (21 mm) and a press, slowly press in the generator coil assembly.
- Install the 4 bolts.
-
Torque:
- 5.8 N*m{
59 kgf*cm
, 51 in.*lbf
}
| 4.
INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
 |
- While pushing the 2 brushes into the generator brush holder assembly, insert a φ1.0 mm (0.039 in.) pin into the brush holder hole.
- Install the brush holder assembly to the generator coil with the 2 screws.
-
Torque:
- 1.8 N*m{
18 kgf*cm
, 16 in.*lbf
}
Pull out the pin from the generator brush holder.
| 5.
INSTALL GENERATOR TERMINAL INSULATOR |
 |
- Install the terminal insulator to the generator coil.
- NOTICE:
- Pay attention to installation direction of the terminal insulator.
| 6.
INSTALL GENERATOR REAR END COVER |
 |
- Install the generator rear end cover to the generator coil with the 3 nuts.
-
Torque:
- 4.6 N*m{
47 kgf*cm
, 41 in.*lbf
}
| 7.
INSTALL GENERATOR CLUTCH PULLEY |
 |
Temporarily install the clutch pulley onto the rotor shaft.
- Set SST (A) and (B).
- SST
- 09820-63020
- Clamp SST (A) in a vise.
Place the rotor shaft end into SST (A).
- Fit SST (B) to the clutch pulley.
- Tighten the pulley by turning SST (B) in the direction shown in the illustration.
-
Torque:
- without SST:
- 110 N*m{
1125 kgf*cm
, 81 ft.*lbf
}
- with SST:
- 84 N*m{
857 kgf*cm
, 62 ft.*lbf
}
- NOTICE:
- Use a torque wrench with a fulcrum length of 318 mm (12.52 in.).
- This torque value is effective when SST is parallel to a torque wrench.
Remove the generator assembly from the SST.
Check that the clutch pulley rotates smoothly.
Install a new clutch pulley cap to the clutch pulley.