Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009from Jun 2009
1.
INSTALL FRONT DOOR OUTSIDE HANDLE SUB-ASSEMBLY
Insert the front end of the front door outside handle sub-assembly into the front door outside handle frame.
Insert the rear end of the front door outside handle sub-assembly into the front door outside handle frame. Slide the front door outside handle sub-assembly to the front of the vehicle to install it.
Connect the connector.
2.
INSTALL FRONT DOOR OUTSIDE HANDLE COVER
Engage the 2 claws to install the front door outside handle cover to the front door lock cylinder.
Install the front door lock cylinder.
HINT:
Make sure that the front door lock cylinder rod is inserted into the front door lock assembly.
Using a "TORX" socket wrench (T30), install the front door lock cylinder with the screw.
Torque:
4.0 N*m{
41 kgf*cm
, 35 in.*lbf
}
Install the hole plug.
3.
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
Insert the front door glass sub-assembly into the front door panel along the front door glass run as indicated in the order of the arrows in the illustration.
Install the front door glass sub-assembly with the 2 bolts.
Torque:
5.5 N*m{
56 kgf*cm
, 49 in.*lbf
}
4.
INSTALL FRONT DOOR SERVICE HOLE COVER
Apply butyl tape to the front door panel.
Pass the front door lock remote control cable and rear door inside locking cable through a new front door service hole cover.
Install a new service hole cover.
NOTICE:
Securely install the front door service hole cover avoiding wrinkles and air bubbles.
Connect each connector and each clamp.
5.
INSTALL FRONT NO. 1 SPEAKER ASSEMBLY
Install the front No. 1 speaker assembly with the 4 bolts.
Connect the connector.
6.
INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY
Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.
Engage the 2 claws and install the front door inside handle sub-assembly.
7.
INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP
Engage the 4 claws and install the front door inner glass weatherstrip.
8.
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Connect each connector.
Engage the front door trim board with the 4 clips of the front door inner glass weatherstrip.
Engage the 9 clips and install the front door trim board to the front door panel.