Antenna Circuit
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The antenna is built into the door outside handle of the driver door and passenger side. Terminals ANT1 and ANT2 of the antenna (door outside handle) detect if the electrical key is within the detection area around the door outside handle.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (ELECTRICAL KEY OSCILLATOR - ANTENNA) |
Remove the outside handle.

Disconnect the antenna and door oscillator connectors.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
- for Front LH Side:
Tester Connection (Symbols)
Condition
Specified Condition
X1-2 (ANT2) - X2-8 (ANT2)
Always
Below 1 Ω
X1-6 (SGT) - X2-2 (SGT)
Always
Below 1 Ω
X1-5 (ANT1) - X2-3 (ANT1)
Always
Below 1 Ω
X1-2 (ANT2) - Body ground
Always
10 kΩ or higher
X1-6 (SGT) - Body ground
Always
10 kΩ or higher
X1-5 (ANT1) - Body ground
Always
10 kΩ or higher
- for Front RH Side:
Tester Connection (Symbols)
Condition
Specified Condition
W1-2 (ANT2) - W2-8 (ANT2)
Always
Below 1 Ω
W1-6 (SGT) - W2-2 (SGT)
Always
Below 1 Ω
W1-5 (ANT1) - W2-3 (ANT1)
Always
Below 1 Ω
W1-2 (ANT2) - Body ground
Always
10 kΩ or higher
W1-6 (SGT) - Body ground
Always
10 kΩ or higher
W1-5 (ANT1) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK AND REPLACE DOOR OUTSIDE HANDLE |
Replace the door outside handle.
Check that the entry LOCK/UNLOCK function operates normally.
- OK:
- Entry LOCK/UNLOCK function operates normally.
|
|
||||
| OK | ||
| ||
