2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Luggage Oscillator Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The certification ECU activates the inner and outer luggage compartment oscillators. The power is supplied from the certification ECU to both the inner and outer luggage compartment oscillators. If the entry luggage compartment function has a problem, check both the inner and outer luggage compartment oscillator circuits.

WIRING DIAGRAM

B147262E03

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ELECTRICAL KEY OSCILLATOR)

  1. B137965E03
    Disconnect the E58 ECU connector.

  1. Disconnect the oscillator connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    E58-16 (CG7B) - N25-3 (CLGB)
    Always
    Below 1 Ω
    E58-15 (CLG7) - N25-1 (CLG6)
    Always
    Below 1 Ω
    E58-32 (CG8B) - S14-2 (CLGB)
    Always
    Below 1 Ω
    E58-31 (CLG8) - S14-1 (CLG5)
    Always
    Below 1 Ω
    E58-16 (CG7B) - Body ground
    Always
    10 kΩ or higher
    E58-15 (CLG7) - Body ground
    Always
    10 kΩ or higher
    E58-32 (CG8B) - Body ground
    Always
    10 kΩ or higher
    E58-31 (CLG8) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK AND REPLACE ELECTRICAL KEY OSCILLATOR
  1. Replace the electrical key oscillator.

  1. Check that the luggage compartment door entry LOCK/UNLOCK function operates normally (outside oscillator) or the key confinement function operates normally (inside oscillator).

    OK:
    Luggage compartment door entry LOCK/UNLOCK function operates normally (outside oscillator) or the key confinement function operates normally (inside oscillator).



OK
END (ELECTRICAL KEY OSCILLATOR IS DEFECTIVE)
NG


3. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Reconnect the oscillator and the ECU connectors.

  1. Connect the intelligent tester to the DLC3.B150920E01

  1. Turn the engine switch on (IG).

  1. Following the display on the tester, select "ACTIVE TEST".

    Entry and Start (Certification ECU): 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    In Bdr Transmitter
    Luggage compartment door inner oscillator
    ON/OFF
    -
    Bdoor Transmitter
    Luggage compartment door outer oscillator
    ON/OFF
    -

  1. B137963E15
    Measure the frequency according to the value(s) in the table below.

    Standard:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    E58-16 (CG7B) - E58-15 (CLG7)
    During ACTIVE TEST
    Frequency is generated (higher than 0 Hz)
    E58-32 (CG8B) - E58-31 (CLG8)
    During ACTIVE TEST
    Frequency is generated (higher than 0 Hz)



NG
REPLACE CERTIFICATION ECU
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Antenna Circuit (from Jun 2009)Luggage Oscillator Circuit (from Jun 2009) →